Original Genset Auto Start Controller Gcu-10 Control Module Gcu10 for Kutai Generator

Controller GCU-10

The generator controller is a sensor and actuator used in the automatic control system. It is used to control the starting, stopping, important parameter measurement, fault alarm, or shutdown protection of the generator. The use of intelligent control systems will greatly improve the efficiency of diesel power generation. The operation of the unit ensures the stable operation of the diesel generator set, saves manpower and material resources, and improves work efficiency.

Categories: Controller, Other Series

Description

Package Size

20.00cm * 15.00cm * 10.00cm

Package Gross Weight

1.000kg

DC Supply	9.0 to 36 VDC
Alternator Input Range	Voltage 5~300 VDC Frequency 50~60 Hz
Fuel Solenoid Signal Output	5 Amp @ 12/24 VDC
Start Signal Output	5 Amp @ 12/24 VDC
Warm-up Signal Output	5 Amp @ 12/24 VDC
Accessory ” ON ” Output	5 Amp @ 12/24 VDC
Idle Control Conductor Capacity	5 Amp @ 12/24 VDC
Power Consumption	Under 3 VA on Auto
Adjustable Timers	Engine Pre-Heat: 2~30 sec. Starter Cranking Time: 1~15 sec. Energize to STOP: 1~15 sec. Engine Idle (Governor): 0~300 sec. Engine Cool-down: 0~300 sec.
Environment	Operation Temperature: -20~70 °C Relative Humidity : Maximum 90%
Protection & Alarm Status Indicators	Start Failure High Water Temperature Low Oil Pressure Overspeed Underspeed Emergency Stop Extra Prog. Input Low Battery Voltage
Panel Installation Cut-Out	66.0 x 66.0 ±0.5 mm
Dimensions	72.0 (L) x 72.0 (W) x 50.0 (H) mm
Weight	166 g ±2%

We manufacture many brands Controller, including DeepSea,ComAp,Smartgen,Kutai, etc.